The WaveMon RF-60 has a shaped (weighted) response to specific standards. It is not a single model trying to follow all standards at the same time. That approach will inevitably result in a lack of accuracy. It is available in different models with specific shaping to follow each standard, for increased accuracy.
ELECTRIC AND MAGNETIC FIELD DETECTION
Isotropic sensors with RMS response
WEIGHTED RESPONSE TO INTERNATIONAL STANDARDS
ICNIRP, European Directive 2013/35/EU, FCC and Safety Code 6 (2015)
HIGH INTENSITY AUDIBLE, VISIBLE AND VIBRATORY ALARM
With user-definable trigger threshold
EXPOSIMETER WITH DATALOGGER
Data collecting and Reporting
GPS AND ALTIMETER
Geolocation of measurements
HUGE AUTONOMY
More than one month using two rechargeable AA batteries
USB COMMUNICATION PORT
Data downloading, set-up and battery charging
DATALOGGER
The WaveMon is a radio frequency exposimeter that have a datalogger for continuous data recording. Communication with the device is through a USB port that allows you to parametrise the device and download the recorded data. This makes it easy to create reports and allows you to keep a record of your exposure data for your safety.
The WaveMon is the only RF personal monitor equipped with a GPS and Altimeter for geolocation of measurements. As an example, in a telecommunication tower, the GPS will provide the geographical position of the tower and the Altimeter the relative height from the ground. Thus, the radio frequency monitor will record ‘Exposure Level’ together with ‘Date’, ‘Time’, ‘Geographical Position’ and ‘Height’ on the Tower, allowing you to perfectly locate the hotspots.
Small and lightweight, the exposimeter runs on to rechargeable AA batteries, charged through the USB port. Can also be used with standard AA batteries, so that you can always find replacements. What could be easier? Wavecontrols wants to make sure you are always protected.
WEIGHTED RESPONSE
The WaveMon has a shaped (weighted) response to specific standards. It is not a single model trying to follow all standards at the same time. That approach will inevitably result in a lack of accuracy. It is available in different models with specific shaping to follow each standard, for increased accuracy.
Introduction and basic usage of the WaveMon
About Wavemon RF-60
Wavecontrol has created a clip on holder that you can fasten to your harness, belt or arm, so that can take it in your hand and hold it close to a source of radiation, and then put it back easily. You can also fasten the WaveMon RF personal monitor to a small carabiner to keep from dropping it.
Railway
Electromedicine
Telecommunications
Detection of Articles and Persons (RFID/EAS)
Laboratories/ R+D
Defense
Energy
Industry